The versatility of Pneumatic high pressure grouting pumps

Peumatic Grouting pump is designed for stress and filling grouting of cement and bentonite slurries. It is primarily used for injecting (grouting) bar anchors and the drill holes in order to reinforce the unfastened rock mass. The maximum grain measurement can’t exceed 0.2 mm.
Grouting pump operation and upkeep is straightforward, safe and dependable. เกจวัดแรงดัน4บาร์ is utilized in mines working under troublesome circumstances as a result of it is reliable and explosion-proof.
Basic Pneumatic Grouting pump embrace: An air inlet, the pneumatic cylinder, mounting base frame and stand, pressure gauge, pumping cylinder, outlet with quick launch coupling and wheels.
How it actually works
Pneumatic pressure within the air cylinder exerts a excessive stress on the grout combination which ends up in ejection of grout with a excessive strain and velocity. The valves of the air cylinder in the pump operate routinely to actuate the cylinder. The pneumatic cylinder then moves the plunger up and down to finish the pumping cycle.
Pneumatic grout pump can be pushed even with out Electrical energy supply in distant areas by using engine driven compressor.
The pump is majorly used in development and mining trade for injecting material into extensive and medium measurement hole in beams, columns ,basement partitions and flooring, raise shaft concrete wall fill-up and so on. In mining trade it’s used to replenish cement solution where there is a hole exists between structure and rock and for soil stabilization.
Detachable design tends to straightforward upkeep and transportation. Challenging works like Grouting in Bridges.
READ: How hydraulic submersible pumps work
This pump is extensively used in tunnels, coal mine, bridges and dams, building basis, and other underground tasks, and inflammable, explosive sites and other dangerous surroundings.
It has software in chemical trade additionally to pump out chemical slurries.
The pump is electricity free so, can be used at any website condition whether or not it is rural or urban.
Mining Pneumatic Grouting pump has a larger discharge slurry adjustment range. Generally the ultimate quantity of the grouting volume is 8 or10 occasions of the amount at first. And the final grouting amount proves that filling is compacted.
Simply put; Pneumatic high-pressure grouting pump is specially designed for high-pressure grouting. And it adopts full hydraulic drive, it’s pressure and flow may be adjusted according to the necessities of grouting,(The circulate of grouting pump is 0-100L/min, strain of discharge is 0-10MPa).in addition to, This Pneumatic high-pressure grouting pump can be utilized for grouting single or double fluid.
High-pressure grouting pump is principally used for highways, railways, water and electricity, development, mining and so on. ground/underground development.
Mining Pneumatic Grouting pump has the benefits of low energy consumption, small vibration, low noise, small measurement, excessive efficiency, dependable efficiency, pressure and flow management, long life and so on. Common mine grouting pump has pneumatic injection pump, twin fluid injection pump, extrusion injection pump and piston injection pump.
Pneumatic grout pump can additionally be Light weight and with a wheelie design it may be carried easily. It is designed for easy operation and low maintenance. Last however not least its spare parts are easily obtainable.

Leave a Comment